Help

Readdress a line in one plan

MCP resource
rdmbench://help/line-plan
Version
0.12.0
Runs on
macOS 15 Sequoia or later, Apple silicon or Intel
Needs
An Enttec DMX USB Pro with its DMX/RDM firmware (major version 2), or, on a rig, an Art-Net 4 node with RDM on at its ports
Price
Free

When a line’s units all need new addresses or modes (units all on address 1, or a rig being repatched), set them together as one plan instead of one unit at a time. The bench checks the whole plan before it sends anything, so a clash that the fifth change would make shows before the first change goes out.

To change one unit, use Change Address and Mode… as in Wrong colors: check the patch. That stays the way to do it on the bench.

In the app, choose Fixture → Change Addresses and Modes on Line…: the plan is a grid of the line’s units, explained under “Change a line in the grid”. (macOS) / This app cannot change a whole line yet. Use the command line below, or change each unit with Change address and mode…. (Windows, Linux)

From the command line

rdmbench-cli set-line --plan plan.csv reads a CSV file with a header line: uid, plus dmx_address and/or personality. A blank cell keeps the unit’s value, and other columns are ignored. Those are the rig sheet’s own column names, so rdmbench-cli scan --all --csv -o rig.csv, edited in a spreadsheet, is a plan.

rdmbench-cli set-line --plan plan.csv --dry-run prints each change as from → to, with anything refused, and sends nothing. Without --dry-run, nothing is sent unless the whole plan passes. Each unit’s result is printed as it goes, and Ctrl-C stops between units.

Two units on some of the same channels are refused. A stack is the exception: units of the same model, in the same mode, on exactly the same channels, which the console drives as one. A stack is printed as STACKED so you can check it is meant, and it does not stop the plan.

rdmbench-cli set-line --plan plan.csv --put-back back.csv also writes the plan that puts every changed unit back. rdmbench-cli set-line --plan back.csv then restores them. If units shared channels before, putting them back puts them on the same channels again: the overlaps are printed, and they do not stop it.

A plan is one line: a sheet with more than one universe in it is refused.