RDMBench 0.6.0
RDMBench 0.6.0, released 2026-10-24 for macOS: each build's file, size and SHA-256.
A version is listed here only once every platform RDMBench is built for has it, so these are all of this version’s builds.
A newer release is out: RDMBench 0.12.0. The app offers it as an update. This version’s files stay where they are, for a bench that needs it.
What’s new
- Change Address and Mode… sets a unit’s start address and personality from its report, the Fixture menu or the sidebar. The address is checked against the chosen mode’s footprint before anything is sent, each change is read back, and a unit that refuses because it is locked is said as locked.
- Sweep Modes… runs the same check — the report, a load, or a channel walk by eye — in each personality you pick, shows the modes side by side with what differs between them, then puts the unit’s own mode and address back. If RDMBench quits partway, the next launch offers to put the unit back.
- The app reaches an Art-Net node, and asks macOS for Local Network access to do it. When a node’s ports give nothing, it says why: RDM turned off at a port, or a node that never runs discovery. It no longer tells you to check the cable.
- DMX through an Art-Net node: Send DMX, the load test, the channel walk and a sweep’s lit checks now work on a rig, but only on a port nothing else is driving. Output ends the moment another source joins, and every hold ends with a frame at zero, since a node repeats its last frame.
- Identify is off when the app connects, on every unit, as each model means it.
- A unit whose two footprints disagree is placed by the smaller. The ADJ 5PX reports 12 channels in every mode, while its 6-channel mode describes itself as six; the load test, the sidebar, Send DMX and Change Address and Mode now use six, and the report says which it used.
- The monitor keeps each unit’s reply times — fastest, typical, slowest — for the session, while dark and during each load hold, so a unit that slows as it warms shows before it starts missing answers.
- A widget’s line is listed in patch order, as a rig’s universe is, and the identify walk follows the sidebar.
- Done waits for the re-read. After a change of address or mode, a sweep, Finish Repair or Match Other Units, the sheet stays open with its spinner until the report shows what the change made.
- Assistants on other computers: a wrong password now waits longer after each of five misses, the load tool always names the unit it will drive, and an assistant can no longer reach a load without the question to you.
- On the command line,
behaviour --fail-on-findingsgives a script an exit status to read, andset-labelprints the label as text again.
Requirements
The manifest does not record what an older build needs. The newest release’s requirements are on Requirements.
macOS
- Build: 20261024.2031
- File: RDMBench-0.6.0-20261024.2031.dmg, 50,833,295 bytes
- SHA-256:
fadc054cb77491f9eca9090f80e69710f4dc8eb1af69b8decd12bdde0cbac6da
To check a download on a Mac: shasum -a 256 RDMBench-0.6.0-20261024.2031.dmg prints
the SHA-256 above.